Page 57 - Florida-Strut-Catalog-2021

Cush-A-Nator®
Cush-A-Nator® – New Installations
Cush-A-Nator® – Retrofit / Replacement Applications
A key feature of the Cush-A-Nator is this ability to place the cushion and rotate into position . Perfect for retrofit applications!
Retrofit - The Common Problem
Replacing a cush-a-clamp within a long pipe run poses a problem . Clamps before and after the one to be replaced prohibit the pipe from being raised so that the new cushion can be installed correctly . All to often a work-around is used which compromises the connection .
A ZSi-Foster Company
Step 2:
Insert the Cush-A-Nator® onto the pipe and then use the exclusive "Thumb Drive" to rotate into position .
Step 3:
Add Pipe Clamps and tighten the assembly .
Step 1:
Retrofit - The Perfect Solution Step 1: Remove Bad Cushion .
Step 3: Rotated into place while on the channel and the Self-Alignment tab automatically aligns with the channel opening ready for clamping .
Rotate into Position
Florida Strut Engineering Catalog
WARNING: These products can expose you to chemicals including lead, which is known to the State of California to cause cancer, and which is known to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Step 2: The Cush-A-Nator can be installed without raising the pipe . The unique "Thumb Drive" allows you to rotate the Cush-A-Nator into position .
Step 4: Add Pipe Clamps and tighten the assembly .
Thumb Drive
"Self-Alignment"
– 57 –
Technical Concrete Rooftop Electrical Beta Clamps Pipe & Conduit General Channel Nuts & Channel Introduction Data Inserts Supports Fittings Supports Fittings Hardware